SEAT Automobiles Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
After a few near misses my front splitter finally bit the dust today (cattle grid straight to ramp at a country park!).

I will be ordering a new one from the dealer tomorrow and would like to fit it myself. Has anyone replaced there's and got any hints/tips? It looks like it just clips in to the bumper but I assume this must be a pretty tight fit given the abuse these take.

Cheers,

Andy
 

·
Registered
Joined
·
553 Posts
I think your right mate, had the one side of mine get detached and it was just a case of forcing the plastic locating thingys (technical speak) back into the bumper.
 

·
Registered
Joined
·
1,834 Posts
Not had to replace mine yet, but I've heard the sides fit quite easily, it's the clips in the middle that are bit of a pain... apparently using a car jack to pop it in place makes the job a lot easier ;)
 

·
Registered
Joined
·
57 Posts
need to get myself a new front splitter!!

out of interest how much was it? is the best place to get one from the dealers? if so could you pass on the part number?

tahnking ya loadz
 
1 - 7 of 7 Posts
Top