SEAT Automobiles Forum banner
1 - 5 of 5 Posts
Joined
·
540 Posts
On the MK1's you unscrew the main screw which holds the light in place. Then get your fingers behind the sides of the lights and pull out - you will need to pull quite hard. Disconnect the wires. Once the light is out you just unscrew the circuit at the back, which has 2 screws. Lift out the circuit and done. Its a 5 minute job to get them both off.
 

·
Registered
Joined
·
4,322 Posts
Exactly the same on the Mk2's yes - open the boot and you'll see the screw by the seal.

If you pull them slightly towards the outside of the car rather than straight back - there are two clip type things holding each one in on the outer edge.
 
1 - 5 of 5 Posts
Top