SEAT Automobiles Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi all
I am trying to remove the trim panel the the rotary light switch is in, drivers "mini" storage unit etc. Found a manual online that has how to remove bits of trim but I can't see one for the bit I want. I have removed the side panel trim between dash and door to look behind but I can't get it to budge at all. I am trying to run a cable for my phone to plug in to the USB port for CarPlay, and then have a Brodit clip to hold phone on the drivers air vent nearest door. The clip itself is not an issue as I can just about get enough of a gap to slip it in, but I want the cable to be in the gap too. Whilst I could pop the little blank where the headlight beam adjust is, I know I won't be happy with that.
Thanks
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top